Developed by Defcon Films Australia

EASIEST PPF TO INSTALL

What makes a film forgiving on the bench, and how to test it.

The easiest PPF to install is the one whose adhesive slides during positioning, grips once placed and lets the film stretch over curves without lifting. Brand matters less than those behaviours, and the only reliable way to judge them is to lay the film yourself. Defcon gloss film uses an easy-tack, repositionable adhesive on aliphatic TPU at 190 microns ±10%. This page sets out what makes a film forgiving for a new installer, which Defcon line to start on, and how to test any film before buying a roll.

What Makes A Film
Easy To Lay

Adhesive behaviour is the number installers ask about. A forgiving film has easy tack, stays repositionable while you line the panel up, then grips once placed. Defcon gloss film is built that way, which shortens installation time on complex panels.

Stretch is the second test. The film has to go over curves and contours without lifting at the edges later. The edge lifting and silvering guide explains how to tell an installation fault from a film defect.

Start With
Flat Panels

FleetArmour is straightforward on large flat sections such as tray sides and sills, and it is priced as a sacrificial layer, so a mistake costs less. Glanz is the clear gloss line to move to when the customer is paying for finish.

The practice order used in Defcon training is preparation first, then squeegee and knife skills, then simple panels such as guards and doors, and only then mirrors and bumper sections.

Slip Solution
Does Half The Work

How easy a film feels depends on what is under it. Placement runs on Installation Gel as the slip solution, and water quality changes how it behaves. The slip solution article covers hard water, and the tools and accessories page lists the squeegees and sprayers.

Cut On A Plotter,
Not On The Car

Cutting off the car from a pattern library keeps the blade away from paint, which is where most film damage claims begin. OEMC pattern software and the DFA Plotter cut patterns in-house.

Defcon film is supplied in full rolls and precut kits are not part of the range. The kits or bulk rolls article compares the two ways of working.

Prep Is Still
A Warranty Condition

An easy install is only a warranted one if the surface was prepared. Cover requires a clean, contaminant-free surface at installation.

Each job is registered through e-Warranty within 7 days of invoice.

The warranty guide separates film faults from installation-related ones.

Test It
Before You Buy

Request a free sample roll and run the same bonnet pattern on it as on the other films you are weighing: film against film in your own workshop.

The Practice Pack is real Glanz plus practice film and tooling, and the free PPF experience day is a no-cost way to handle the film first.

Training
And Support

The 3-Day PPF Installation Training takes a class of no more than four trainees through preparation, film handling, trimming and finishing.

Technical support continues after the course, in English or Chinese. The how to become a PPF installer page lays out the full pathway.

FAQ

Developed by Defcon Films Australia

Every Defcon film is built for Australian conditions: materials selected globally, proven on local roads, and made to install well.

0
0
Your Cart
Your cart is emptyReturn to Shop